Email:sales@lztonghesheng.com Laizhou Tonghesheng Hydraulic Machinery Co.,Ltd

Laizhou Tonghesheng Hydraulic Machinery Co.,Ltd

Product Categories
Contact Us

Laizhou Tonghesheng Hydraulic Machinery Co.,Ltd

Address:Xingshi West Road, Wenfeng Subdistrict, Laizhou City, Shandong, P. R. China

Tel:86-535-2423426   

Fax:86-535-2423426   

Email:

sales@lztonghesheng.com

manager@lztonghesheng.com

Website:www.lztonghesheng.com

Hydraulic Cylinder Operation

Hydraulic cylinders get their power from pressurized hydraulic fluid, which is typically oil. The hydraulic cylinder consists of a cylinder barrel, in which a pistonconnected to a piston rod moves back and forth. The barrel is closed on one end by the cylinder bottom (also called the cap) and the other end by the cylinder head (also called the gland) where the piston rod comes out of the cylinder. The piston has sliding rings and seals. The piston divides the inside of the cylinder into two chambers, the bottom chamber (cap end) and the piston rod side chamber (rod end / head end).

Flangestrunnionsclevises, and lugs are common cylinder mounting options. The piston rod also has mounting attachments to connect the cylinder to the object or machine component that it is pushing or pulling.

A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. The piston pushes the oil in the other chamber back to the reservoir. If we assume that the oil enters from cap end, during extension stroke, and the oil pressure in the rod end / head end is approximately zero, the force F on the piston rod equals the pressure P in the cylinder times the piston area A:

     F=P · A


Retraction force difference

For double-acting single-rod cylinders, when the input and output pressures are reversed, there is a force difference between the two sides of the piston due to one side of the piston being covered by the rod attached to it. The cylinder rod reduces the surface area of the piston and reduces the force that can be applied for the retraction stroke.

During the retraction stroke, if oil is pumped into the head (or gland) at the rod end and the oil from the cap end flows back to the reservoir without pressure, the fluid pressure in the rod end is (Pull Force) / (piston area - piston rod area):

QQ图片20181001104138.png

Where P is the fluid pressure, Fp is the pulling force, Ap is the piston face area and Ar is the rod cross-section area.

For double-acting, double-rod cylinders, when the piston surface area is equally covered by a rod of equal size on both sides of the head, there is no force difference. Such cylinders typically have their cylinder body affixed to a stationary mount.


Previous: No Information

Next: Steam Engines

Copyright © Laizhou Tonghesheng Hydraulic Machinery Co.,Ltd All rights reserved.
QR Code